Lithofin MN Colour Intensifier

 
A special product from the LITHOFIN-Range for marble, natural and engineered stone (MN). This ready-to-use siloxane impregnator is solvent based and contains special colour intensifying components.

Properties Lithofin MN Colour Intensifier penetrates into the surface rendering it water repellent while at the same time intensifying the colour without producing any gloss. Surfaces appear more colourful and fresh - "wet effect". The water resistance reduces the sensitivity of the surface, largely preventing staining and facilitating maintenance. Lithofin MN Colour Intensifier does not form any layers, thereby maintaining the surface's water permeability. The slip resistance of the surface is hardly affected. Durability: indoors and with correct maintenance nearly unlimited. Outdoors, depending on the type of stone, the colour will remain for approx. 1 to 2 years, the protective effect for several years. Can be reapplied when the effect fades.

Technical Data

• Density: approx. 0,85 g/cm³
• Appearance: liquid, colourless, clear
• Odour: aromatic
• pH-Value: n.a.
• Flash Point: >25°C
• Solubility in Water: not soluble

Field of Use
For adding lustre to wall and floor surfaces, stairs, entrance areas, terraces, etc. which appear bland and colourless. Suitable for indoor and outdoor use.

Directions for Use
The surface to be treated must be completely dry and clean. Always try the product in an inconspicuous area prior to use. Evenly apply a consistent amount of Lithofin MN Colour Intensifier with a clean brush, a roller or a cloth. On highly absorbent surfaces, this procedure may have to be repeated after five minutes. The product should saturate the stone without drying on the surface. Less absorbent surfaces may have to be towelled off. Attention! treat only completely dry surfaces (drying time for newly laid surfaces; up to 8 weeks; after rain or after cleaning: several days). Non-absorbent surfaces such as polished or fired materials such as porcelain or ceramic tiles can not be treated. Glass, wood, plastics and other surfaces sensitive to solvents must be protected against splashes.

Coverage: approx. 10m² per litre depending on the surface.

Surfaces: all absorbent, porous natural stones (e.g. granite, gneiss, porphyr, marble, limestone, slate, etc.) and engineered stones with rough, sawn, honed and flamed surfaces.

Please Note: For protecting polished and very finely honed natural and artificial stones, we recommend Lithofin MN Stain-Stop or Dry Treat STAIN-PROOF Original™.

Drying Time: Safe to walk on after approx. 30 minutes, completely dry after 24 hours.

Application Temperature: The temperature of the surface should be between 5°C and 25°C. Switch off under floor heating.